Product Name

Ylang Ylang Essential Oil

Supplier

Just a Soap

South East Lodge

Rede Road

Whepstead

Bury St Edmunds

Suffolk

IP29 4ST

 

Composition/Ingredients Information

Definition: the oil obtained by steam distillation of the dry, fresh picked flowers of Cananga odorata (DC) Hook f. et Thoms subsp. Genuine (Fam.Anonaceae)

INCI: Cananga odorata Flower Oil

CAS number: 8006-81-3

EINECS Number: 3301 29 11

Tariff Number: NIOSH ZF 91160000

CoE Number: 103

FEMA: 3119

Status: natural

Additives: none

IFRA: not restricted

RIFM: monograph

Hazard Identification

Concentrated product.  Do not ingest.  Observe good housekeeping procedures when handling.

First Aid Measures

Inhalation: Remove from exposure site to fresh air

 

Eye contact:  Rinse immediately with plenty of water for at least 15mins. Contact a doctor is symptoms persist.   

 

Skin contact:   

Remove contaminated clothes.  Wash thoroughly with soap and water.

 

Ingestion:             

Rinse mouth out with water.  Seek IMMEDIATE medical advice.

Fire-Fighting Measures

Extinguishing media: CO² dry powder or foam extinguishers.  Do not use water jets.

Special measures: avoid vapour inhalation.  Keep away from sources of ignition.  Protective clothing and breathing apparatus should be worn.

Extinguishing procedures: closed containers may build up pressure when exposed to heat and should be cooled with water spray.

Accidental Release Measures

Personal precautions: avoid inhalation and direct contact with eyes. 

Prevent from entering drains, surface and ground waters.

Cleaning: remove using absorbents then clean the area with hot water and detergent.

Handling and Storage

Normal hygiene practices should be employed.

Storage conditions:             

Store in tightly closed original container, in a cool, dry and ventilated area away from heat sources and protected from light.  Keep away from possible sources of combustion.

Exposure Control/Personal Protection

Precautions: goggles and gloves should be worn if there is a risk of splashing.  Avoid breathing vapours.

Physical and Chemical Properties

Appearance @ 20º C: pale to dark yellow mobile liquid.

Odour: exotic, warm spicy, balsamic.

Specific gravity @ 20º C: 0.906-0.976

Refractive index @ 20º C: 1.495-1.513

Flash point: º C  87

Solubility in 95% ethanol: partially soluble.

Stability/Reactivity

Materials to avoid: Strong acids, alkali or oxidizing agents. It presents no significant hazard by itself or in

contact with water.

Conditions to avoid: Oxidation promoting conditions (heat/light)

Decomposition: Liable to cause smoke & acrid fumes during  combustion: carbon monoxide, carbon dioxide

& other non-identified organic compounds may be formed.

Toxicological Information

LD50 ORL-Rat>5g/kg  LD 50 skn-rbt>500mg/kg 24H MLD

RIFM monograph (1974) FC 12, 807:non irritating, non sensitising to non phototoxic to human skin: FCT 12 (Suppl.),1015.

Ecological Information

Data not available.

Disposal Considerations

Dispose of according to local and national regulations. 

Transport Information

Not considered hazardous for transport.

CHIP see section 15

Regulatory Information

According to Directive 88/379/EEC

Hazards: n/a

Symbols: n/a

Risk Phrases: n/a

Safety Phrases: n/a

Other Information

Cosmetics Directive 7th Amendment: Restrictions may apply.  A source of Benzyl alcohol, Benzyl slicylate, Eugenol, Geraiol, Isoeugenol, Benzyl benzoate, Farnesol and Linalool listed as sensitizers.  Check maximum usage levels for skin care products.

 

Suitable Packaging: Glass, Lacquer lined steel/tin, Aluminium,  F/HDPE.

 

Shelf Life: 3 years maximum. Re-test after 12 months


The data provided in this material safety data sheet is meant to represent typical data/analysis for this product and is correct to the best of our knowledge. The data was obtained from current and reliable sources, but is supplied without warranty, expressed or implied, regarding its’ correctness or accuracy. It is the user's responsibility to determine safe conditions for the use of this product, and to assume liability for loss, injury, damage or expense arising from improper use of this product. The information provided does not constitute a contract to supply to any specification, or for any given application, and buyers should seek to verify their requirements and product use.