|
Product Name
|
Orange Colour Liquid
|
|
Supplier
|
Just a Soap
South East Lodge
Rede Road
Whepstead
Bury St Edmunds
Suffolk
IP29 4ST
Tel: 01284
735043
|
|
Composition/Ingredients Information
|
INCI name: CI 15510.
|
|
Hazard Identification
|
Generally
non hazardous
|
|
First Aid Measures
|
Inhalation:
Remove
from exposure site to fresh air. Keep at rest. Obtain medical attention.
Eye
contact:
Rinse immediately with plenty of water for at
least 15 mins. Contact a doctor if symptoms persist.
Skin contact:
Remove
contaminated clothes. Wash thoroughly with soap and water, flush with
plenty of water. If irritation persists, seek medical advice.
Ingestion:
Rinse
mouth out with water. Seek medical advice immediately.
|
|
Fire-Fighting Measures
|
Extinguishing
media RECOMMENDED:
Use
CO2, Dry Powder or Foam Extinguishers, spraying extinguishing media to base
of flames. Do not use direct water jet on burning material.
Special
measures:
Avoid
vapour inhalation. Keep away from sources of ignition. Do not smoke. Wear
positive pressure self-contained breathing apparatus and protective
clothing.
Extinguishing
procedures:
Closed
containers may build up pressure when exposed to heat and should be cooled
with water spray.
|
|
Accidental Release Measures
|
Personal
precautions:
Avoid
inhalation and direct contact with skin and eyes. Use individual protective
equipment (safety glasses, waterproof-boots, suitable protective clothing)
in case of major spillages.
Environment
precautions:
Keep
away from drains, soils, surface and groundwaters.
Cleaning
up methods for spillages:
Remove
all potential ignition sources. Contain spilled material. Cover with an
inert or non-combustible inorganic absorbent material, sweep up and remove
to an approved disposal container. Observe state, federal and local
disposal regulations.
|
|
Handling and Storage
|
Precautions
in handling:
Apply
good manufacturing practice and industrial hygiene practices, ensuring
proper ventilation. Observe good personal hygiene, and do not eat, drink or smoke whilst
handling.
Storage
conditions:
Store
in tightly closed original container, in a cool, dry and ventilated area
away from heat sources and protected from light. Keep air contact to a
minimum.
Fire
protection:
Keep
away from ignition sources and naked flames. Take precautions to avoid
static discharges in working area.
|
|
Exposure Control/Personal Protection
|
Respiratory
protection:
Avoid
breathing product vapour. Apply local ventilation where possible.
Ventilation:
Ensure
good ventilation of working area.
Hand
protection:
Avoid
all skin contact. Use chemically resistant gloves if required.
Eye
protection:
Use
safety glasses.
Work/Hygiene
practices:
Wash
hands with soap and water after handling.
|
|
Physical and Chemical Properties
|
Colour:
Orange
Appearance: Clear, mobile
liquid
FLASH
POINT °C: n/a
|
|
Stability/Reactivity
|
Reactivity:
No data
available
Decomposition: No data available
|
|
Toxicological Information
|
No known hazards.
|
|
Ecological Information
|
Biodegradability:
Data
not available
Precautions:
Prevent
surface contamination of soil, ground and surface water.
|
|
Disposal Considerations
|
Avoid disposing into drainage systems and into the
environment.
|
|
Transport Information
|
Road
(ADR/RID): n/a
Air
(IATA): n/a
Sea
(IMDG): n/a
|
|
Regulatory Information
|
According
to Directive 88/379/EEC
Hazards: n/a
Symbols: n/a
Risk Phrases: n/a
Safety Phrases: n/a
|
|
Other Information
|
The
data provided in this material safety data sheet is meant to represent
typical data/analysis for this product and is correct to the best of our
knowledge. The data was obtained from current and reliable sources, but is
supplied without warranty, expressed or implied, regarding its’ correctness
or accuracy. It is the user's responsibility to determine safe conditions
for the use of this product, and to assume liability for loss, injury,
damage or expense arising from improper use of this product. The information
provided does not constitute a contract to supply to any specification, or
for any given application, and buyers should seek to verify their
requirements and product use.
|